Zenner multipulse Instrukcja Użytkownika

multipulse, multilogInstallation and operating manualElectronic pulse counter module with 3 inputs for connection of meters with pulse outputs Ene

Level 1 Level 2HHLLYou can switch levels at any point in the menu.HHLMonthly consumptionLSSHLHLLLKälte am StichtagMonatswerte KälteDate SRDSRD value

LegendPress the button briey (S), to switch through the display from top to bottom. When hav-ing reached the last menu item the device automatica

Disposal Attention: This device contains a non-remova-ble and non-rechargeable lithium battery. Batteries contain substances, which could harm the en

General informationWith multipulse resp. multilog you have acquired one of the most up-to-date and modern electron-ic pulse counter modules currently

Technical dataDispay Multifunctional LCD, 8-digit, oatingInterface meter Models with contact pulsers or active pulsers (no Namur or Opto)

If water meters with a potential free reed contact are connected to the inputs the connection can be made in any direction.The connectors are given tw

DimensionsHeight: H = 106 mmWidth: B = 126 mmDepth: T = 54 mmCommunicationThe pulse values can be programmed via the software GMM. The pulse value

Subject to modications and errors excepted. Any liability for misprints excluded. SAP124288_150601_ENInstallation instructionsSafety instructionsThe

Installation pulse counting moduleZENNER recommends to mount the module on the wall.Do not mount the device at the pipe or attach it directly on the m

Operation testCheck the pulse counter module for any error codes in the display after installation (see table for error codes).Most of the errors can

Status display / Error codesThe symbols in the table below show the pulse counting module’s operational status. The status messages only appear in the